Single zone mixer amplifier with 120 watts of power for 5 channels.

Single zone mixer amplifier with 120 watts of power for 5 channels.

• Each channel has its own volume control.
• There is also a master volume control as well as a bass and treble control.
• As input sources, the AMP 120 offers connections for 5 microphones and/or 4 line inputs (AUX/TEL).

Additional features:

• protection circuits for overload, overtemperature and short circuit
• speaker connection for 8 Ohm and 70/100V
• Power supply: 115/230V AC or 24V DC
  Note: When using external batteries (24V DC), the AMP 120 must be grounded via the GROUND screw on the back.
• Dimensions, 19″ installation, 2 height units (2 HE)
• Rack mounting or usable as a tabletop device

Note: The mixer amplifier offers phantom power for condenser microphones , which can be individually configured (via jumpers on the input circuit board in the device). When delivered, the jumpers are set so that no voltage is available. The voltage is provided by replugging them.

 

connections

Inputs:

• Ch1: Microphone 1 (XLR, 3-pin)
• Ch2: Microphone 2 (XLR, 3-pin)
• Ch3: Microphone 3 (XLR, 3-pin) or telephone system connection (screw terminal), selectable
• Ch4: Microphone 4 (XLR, 3-pin) or AUX1 (Cinch), selectable
• Ch5: Microphone 5 (XLR, 3-pin) or AUX2(Cinch), selectable
• Adjustable LineIn: AUX3 (Cinch)

Priority: Mic1 > Mic3 > Mic4 > Mic5 > AUX

Note: The AUX inputs are designed as double RCA sockets with stereo-to-mono conversion. The outputs of the connected devices must be suitable for connecting the left and right channels!

Outputs:

• Speaker connection: 8 Ohm and 70/100V (screw terminals)
• Tape Out: Output for recording device (Cinch)
• AUX Out: Output for cascading up to 3 AMP 120

Mute function:
Mute all sources: screw terminal on the back, bridged

Note: If the factory-installed bridge is opened, all sources will be muted, including microphone 1~5 and AUX 1~3.

Show

The device has a 7-digit status display on the front:

• power indicator (green LED / ON)
• output level indicator (5 green LEDs)
• overload indicator (red LED)

scope of delivery

• AMP 120
• 19″ mounting bracket
• device feet (mounted on the device)
• power cable

Matching speakers

• All low-impedance speakers 4/8 Ohm (2 × 8 Ohm / 1 × 4 Ohm) can be connected. Speaker connection with speaker cable 2x 1.5 (max. 50m to the last speaker).
• All 100V ELA loudspeakers with a maximum output of 120 watts for the sound zone. Loudspeaker connection with Y-St(Y) 2x2x0.8 (max. 200m to the last loudspeaker).